** DISCONTINUED MODEL – ONE ONE LEFT IN STOCK**
The curve ended straps are no longer being manufactured; availability of current models is only as shown.
This strap is compatible with the many deployment clasps on the market, namely the OMEGA one that does not require strap loops, as the tail of the strap goes under and not over the deployment clasp.
The strap does not come with a buckle, therefore there is no notch cut out for the buckle tang, which is an issue once fitted to the OEM clasp.
If you are not familiar with these curve ended straps, they have an insert at the watch end, that gives the option to alter the position of the spring bar in relation to the watch case offering a tight perfect fit.
This strap is a genuine Alligator and was possibly a special order as these were not in main production.
This watch strap fits close to the watch case in the same way a metal bracelet does, without gaps.
Please check suitability as not all watches will suit this strap.
Upper Leather: GENUINE ALLIGATOR
Strap Length (excluding buckle): 1 / 80mm approx.
Comes complete with Spring Bars –
|STRAP SIZE GUIDE (mm)
**Product may differ slightly to image & watch not included**
For a Hirsch Curved End Watch Strap fitting guide, please see below:
Many people do not fully understand how these straps work and without having the strap in your hand, it can be hard to visualise it. What makes these straps great is their micro adjustment and universal fit, making them compatible with a lot of watch cases.
Concealed within the watch lug end of the strap is a small plastic insert which has two spring bar holes. It is this small piece of plastic that can be removed and rotated to adjust the spring bar position. You can now fine tune the spring bar position of the watch strap to suit the position of the spring bar holes on the lug of your watch. This may take a few attempts and some trial and error but once you have the position for one side of the strap, the other side should be the same.
Firstly, it is always good practice to tape up the lugs of your watch using masking tapes to prevent scratches when trying to fit any strap.
To remove the plastic insert from the strap, you will need to apply some force to slide it out using a Spring Bar Tool. We recommend sliding the insert out from left to right
Once you removed the plastic insert, you will see that it is numbered on the sides. We have included a key in the photos of this listing that shows the position of the lug holes when the plastic is inserted in that specific position. Reinstall the plastic insert by pushing it back in to the strap from right to left. Be sure that the insert is in just past the line of the leather otherwise this could mark the lugs of your watch. Then insert your spring bar into the correct slot and fit as normal.